We offer specialty hardware designed specifically for cell towers and poles, power transmission towers, and radio towers; whether for new construction, modifications, or repairs. Our fasteners are available in a variety of corrosion-resistant finishes, and can be. HARDLOCK Nut (HLN) offers a proven anti-loosening solution for critical joints and components in tower infrastructure, reducing inspection frequency and long-term maintenance costs. Communication Towers Transmission Towers From high-altitude communication towers to high-voltage transmission lines. This is where HARDLOCK® nuts provide a proven, engineering-driven solution. Tower structures are exposed to a unique combination of real-world stresses: Standard fastening systems rely on friction, which degrades over time—leading to loss of preload and eventual loosening. We have the following types of communication tower products available: GCF. Composite & Hybrid Solutions – fiber-reinforced polymer (FRP) fasteners offer functional advantages in installations where electrical isolation or non-magnetic assemblies are required.
[PDF Version]
The clear space below the leveling nut is not limited by the TIA-222 Standard; however, the ASCE Manual(1) suggests limiting the distance to two bolt diameters. The application discloses a reinforced anchor bolt structure for a communication iron tower, which relates to the technical field of anchor bolt fixation, and comprises an externally connected anchor bolt, an internally fixed anchor bolt, a mechanical anchoring mechanism and a chemical anchoring. ASMTower performs the required structural analysis and designs of telecom towers according to the requirements of the design code used. ASMTower is capable of performing the analysis and design of telecom towers according to the following standards. The vertical supports have lattice members connected to each other with diagonal bracing at lower. GCF manufactures an entire line of special fully engineered Communication Tower Products. The original tower was over 50 years old. When the 2-1/2″ diameter anchor bolts were poured too low, the contractor needed a quick fix so the project would not be delayed.
[PDF Version]
For multi-bolt joints, overall resistance is effectively the resistance of a single bolt divided by bolt count—making torque consistency even more critical. For copper busbars wider than 40 mm, use M12 bolts, 30–50 mm spacing, and torque values above 70 N·m. Failure to follow these instructions can result in injury or equipment damage. That same joint, undertorqued by 30%, runs 80–100°C above ambient within months as micro-gaps develop, contact resistance increases, and oxidation accelerates. Over-tightening may have the same consequences as under-tightening. For connecting busbars (Cu ETP-NFA51-100) to the circuit breaker, the tightening torques to be used are shown in the. * Bronze alloy bolts shall have a minimum tensile strength of 70,000 pounds per square inch. ** Bolts, cap screws, nuts, flat washers, locknuts: 18-8 alloy. Uniswitch switchgears are either fixed or withdrawable type cubicles.
[PDF Version]Contact us for competitive quotes on any of our fiber optic and telecom products
Get a Quote